Hi, I've been trying to setup a Pi-hole using a Raspberry Pi Zero 2 W. The problem is that every Querry results in a 'SERVFAIL', the network router also doesn't make use of the pi-hole as DNS server. I think this is because the system time is not synchronized. I am trying to make use of this pi-h…

I have fixed my problems! The issue was that I was using my router in AP mode, which gave me limited settings. I had it set up this way because I couldn't get a wifi connection unless I used AP mode. I learned some stuff along the way and now I have bridged my modem so only my Asus router has rou…

[image] deHakkelaar: Pi-hole needs to be the only DNS server for your clients: It is. He just saying that if he manually configs (aka, in Windows as a 'Custom Setup') Windows to point to the pi-hole, after trying to use DHCP to assign it, it is still not using it. Some of my devices are ma…

If you are going to install Bullseye, as I suggested and bydeHakkelaar, there is a new version Raspberry Pi Imager v1.7.1. to use to write the card. People have mixed results trying to command line to upgrade; I was told this by a mod that had mixed results. Not to mention if this is just somethin…

It is just that I see a some things lost in translation e.g. below there is a misunderstanding by deHakkelaar about configuring a windows device to use Pi-hole DNS lookup and configuring another device too to use, I presume a Windows device, for DNS lookup.

I think the misunderstanding is on your side: [image] LilRedDog: [image] deHakkelaar: Even when I select the Pi as a custion IPv4 DNS server in Windows 10 no traffic is going through the Pi-hole. [/quote] Pi-hole needs to be the only DNS server for your clients: It is. We don't kn…

I have conflated this thread with another.

Sorry, I did mean all those are set up when Raspian was installed. And by settle in I mean when I set up Bullseye it just would not come off GMT for minutes; even though every time I looked, under settings it was all correct. It took so long I even tried a reboot but about 7 minutes later it, final…

I don't have access to my RPi right now, will try some things after the weekend

[image] deHakkelaar: If so, make sure you do below: Pi-Hole Unbound and Cloudflare TLS Have you hashed out below line: pi@ph5b:~ $ sudo nano /etc/resolvconf.conf [..] #unbound_conf=/etc/unbound/unbound.conf.d/resolvconf_resolvers.conf And deleted below file: pi@ph5b:~ $ sudo rm /etc/unbound/un…

[image] thofra01: netsh interface ip show dnsservers ... 89.101.251.228 Above DNS IP is not Pi-hole or running through Pi-hole: pi@ph5b:~ $ dig +short -x 89.101.251.228 089-101-251228.ntlworld.ie. And I should have supplied you also with the IPv6 version for that command: netsh interface i…

A recent firmware version has severly limited the amount of settings I can change: [RouterSettings] I cannot disable DHCPv4 nor IPv6 using the web-gui. SSH is available on this router so I can try using that but haven't been able to find a solid guide on how to disable those settings. Do you hav…

Pi-hole Userspace

Unable to synchronize system time, Pi-hole not working

Help

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled