The Internet Setup area was the only location within the router to set DNS. The area where DHCP is set only has the options shown of start/end IPs, nothing else. What you see on that screenshot is what you get.
Before I undo all these changes and make additional, I just want to bounce my steps off you for review:
- Revert changes on MI424WR for both the bridge and ethernet/coax levels
- Set DNS on the NetGear back to "Get Automatically from ISP"
- Uncheck the "Use Router as DHCP Server" on the NetGear
- Go into the Setting section of the Pi Hole UI
(and this is where I need help)
- Check "DHCP Server Enabled"
- Do I do anything to the range of IPs to handout, or leave as "10.0.0.201 - 10.0.0.251"?
- Do I want to check "Enable IPV6 Support"?
- Under Advanced DHCP Settings, should I keep the Domain set as "local"?
- Under Advanced DHCP Settings, should I keep the Lease Time as "24"?
- Do I need to make any changes under the DHCP Leases section?